1934830 - How to enable both Pre-generation and Post-generation Transformations - SAP PD 16.5 | SAP Knowledge Base Article

SAP Knowledge Base Article - Preview

1934830 - How to enable both Pre-generation and Post-generation Transformations - SAP PD 16.5

Symptom

How to enable both Pre-generation and Post-generation Transformations when generating a PDM from a LDM?

In a LDM (Logical Data Model),  I create an Extension (XEM). In the XEM, I create two transformations:

  • Transformation 1 is for Pre-generation
  • Transformation 2 is for Post-generation

When I run "Generate Physical Data Model", I select the 'Enable Transformation' option. I expect to see options to select both the pre and post generation Transformations. However, only the Pre-generation tab is available. How do I enable the Post-generation transformation?


Read more...

Environment

  • SAP PowerDesigner (PD) 16.5

Product

SAP PowerDesigner 16.5

Keywords

"physical data model", "Updating existing physical data model" , KBA , BC-SYB-PD , PowerDesigner , How To

About this page

This is a preview of a SAP Knowledge Base Article. Click more to access the full version on SAP ONE Support launchpad (Login required).

Search for additional results

Visit SAP Support Portal's SAP Notes and KBA Search.