1928192 - Using timestamp ranges in SE16 | SAP Knowledge Base Article

SAP Knowledge Base Articles - preview

1928192 - Using timestamp ranges in SE16


When accessing transaction SE16 and trying to select the entries of a specific timestamp interval, the following might happen:

  • Case 1: A timestamp range is specified as per the image below:


and the error Lower limit is greater than upper limit is presented:


  • Case 2: A valid timestamp is specified, but the expected entries are not returned.

An example can be seen in the image below: 


It is expected that all the results between 03.09.1997 02:00:00 and 05.09.1997 03:00:00 are displayed, but instead the entries are not returned or the message No table entries found for specified key is shown


If the fields that specify the time (in this case ERNAM) are left empty, the results are displayed:


And the entries above satisfy the range between 03.09.1997 at 02:00:00 and 05.09.1997 03:00:00.



NetWeaver Release-independent.


SAP NetWeaver all versions


SE16, Timestamp, Date, Time, Wrong, Filter, Incorrect, Interval, Range, Selection, Does not work, Data browser, Timeframe , KBA , BC-DWB-UTL , Workbench Utilities , BC-ABA , ABAP Runtime Environment - ABAP Language Issues Only , Problem

About this page

This is a preview of a SAP Knowledge Base Article. Click more to access the full version on SAP ONE Support launchpad (Login required).

Search for additional results

Visit SAP Support Portal's SAP Notes and KBA Search.