SAP Knowledge Base Article - Public

3006579 - Error: "Servererror (2) Invalid custom member: Formula member C4A#CALC101 uses the not exiting member" appears in tables with calculations in SAP Analytics Cloud (SAC) & SAP Digital Boardroom

Symptom

The following error occurs in tables based onthe same model in SAP Analytics Cloud (SAC):

  • Servererror (2) Invalid custom member: Formula member C4A#CALC101 uses the not exiting member

Environment

  • SAP Analytics Cloud (Enterprise) 2020.21

Reproducing the Issue

  1. Open the story.
  2. Observe that  some table are missing data. Only tables which contain calculated measures are affected.
  3. Change the filtering on the page to another selection.
  4. Observe the error message: "Servererror (2) Invalid custom member: Formula member C4A#CALC101 uses the not exiting member".
  5. Completely remove the filter for the dimension
  6. All key figures can be displayed, including the calculated key figures.
  7. Rebuild the story based on model - issue do not appear.

Cause

This issue is currently under investigation by development.

Resolution

This issue is currently under investigation by development.

See Also

Your feedback is important to help us improve our knowledge base.

Keywords

SAP Cloud for Planning, , Cloud for Analytics, Cloud4Analytics, CloudforAnalytics, , SAC, SAP AC, Cloud-Analytics, CloudAnalytics, SAPCloudAnalytics,Error, Issue, System, Data,, Unable, Access, Story , Sac, Connector,Up, Set, setup, Model,,, Story,,, Using, Working,,, sapanalyticscloud, sap analytical cloud, sap analytical cloud, SAC, sap analyst cloud, connected, failure, stopped, loading, table, Formula member C4A#CALC101 uses the not exiting member,C4A#CALC101, error C4A#CALC101, formula member , KBA , LOD-ANA-DES-CAL , SAC Story Calculations , Problem

Product

SAP Analytics Cloud 1.0